1440 Timberwolf Drive, PO Box 964, Holland, OH 43528-0964 USA | 1 (419) 867-5400 | Email Us

1440 Timberwolf Drive, PO Box 964, Holland, OH 43528-0964 USA
1 (419) 867-5400 | Email Us

Volumes

Sample Type Required Quantity Equipment Used
Bottles 12 Top Load Balance Height Gage

Purpose

This procedure is used to determine the overfill (brimful) and fill line volume of each container in a set. This test can be used for either statistical information like average and standard deviation numbers or can be used to obtain mold specific information. Our typical test is either 12 samples chosen at random from a full mold round or it could be one container from each blow mold cavity.


Description

The overfill and fill line volumes are determined on twelve containers. Overfill is simply filling the container to a level equal to the top of the finish of the container. The typical methods for measuring fill line volume are: 1. Filling the container to a specific height and measuring the volume at that point. 2. Filling the container with a specific volume of water and measuring the height of the liquid and comparing it to the target height. The weight of the water at these two points is used to calculate the volume of the container by dividing the weight by the density of water at the recorded temperature.